Airbrush Motive 045 - Step 4

Adjust the pressure of the air compressor on 1.5 bar.

Note:

Use a respirator and pay attention that your workplace is enough ventilated.

Hold the template with the ornament motive on the fingernail approximately like in the picture on the right side shown.

Use the airbrush pistol with the 0.3 mm nozzle. Fill into the paint cup a drop of the water soluble airbrush colour in blue. The distance of the nozzle to the fingernail should be 2 or 3 cm, as right in the picture shown.

Pull the operating lever 3/4 back when spraying to regulate the colour. Press at the same moment the operating lever half down to regulate the air flow (double action principle), as right shown.

Start with the movement when spraying somewhat beside the fingernail. Move the airbrush pistol steady-going from the left to the right side and from the right to the left side.

The result should correspond approximately to the picture on the right side.

Now hold the template with the ornament motive on the left side of the fingernail tip and move the airbrush pistol steady-going from the left to the right side and from the right to the left side.

The result should correspond approximately to the picture on the right side.

Note:

Before you continue with step 5, wait until the sprayed airbrush colour on the fingernail is dried.